About This

• Annular cutters made with super tough M2AL high speed steel (HSS) for durability, wear resistance, high efficiency and superior service life
• HSS annular drill bits with Outside Diameter 2 inch with 2 inch cutting depth
• CNC-machined high precision drill bit cutter with 3/4 inch Weldon shank (with 2 flats) for secure clamping and edge finish designed for smooth, reamed, burr-free edges of drilled holes. Use a firm steady pressure throughout the cut for best results
• IMPORTANT Drill single layers of materials only. This series of annular cutter is NOT designed for drilling of multiple layers.
• Avoid premature failure of cutter by using a low feed rate when engaging the bit with the work piece, especially for the smaller cutters. Increase to recommended rate once bit is about 2-3mm in.
• Secure workpiece firmly before drilling. If workpiece is less than 1/2” thick, use a 3/8” steel sheet under it to ensure the magnetic drill will grip it firmly. There should be no movement between the workpiece and bit during drilling.
• Compatible with various brands of mag drill including Alfra, BDS, Dewalt, Fein, Euroboor, Hougen, Ruko. Caution: if you want to use this 2 inch annular cutter on a drill press, you need an extra annular cutter arbor for the 2 inch bit. Arbor is not included in this pack.
• Sturdy plastic case holding one annular cutter, one pilot pin

Overview

• Material : High Speed Steel (HSS)
• Cutting Diameter : 2 Inches
• Finish Type : Uncoated
• Shank Type : Weldon
• Brand : S&F STEAD & FAST